杭州城市交通拥挤现状及对策

在分析杭州市交通供需现状的基础上,提出了规划多中心结构和混合功能区,以减少不必要的出行以及合理配置交通源,并对改善中心区交通提出切实可行的对策。     

大断面地铁车站隧道软弱围岩渐进破坏规律模型试验研究

以贵阳市地铁2号线阳明祠车站为背景,采用室内模型试验模拟大断面地铁车站施工过程中隧道塌方破坏过程,明确施工期间大断面隧道塌方破坏过程机制,对比分析围岩和路面的变形。结果表明:通过围岩重力作用模拟隧道施工过程中塌方过程,与实际塌方过程基本吻合,弥补了常规加载破坏的不足;围岩渐进破坏过程表现为裂隙出现-裂隙发展-裂隙贯通-围岩塌方,支护渐进破坏过程表现为变形缓慢增加-变形快速增加-裂缝快速发展-支护破坏;围岩渐进破坏与支护渐进破坏相互作用,共同发展;在实际施工过程中,当支护变形大幅增加时,应增加支护强度,同时还应及时注浆、打设长锚杆,以减缓围岩裂隙发展,阻断围岩渐进破坏过程。     

Analytical and simulation approaches to understand combined effects of transit signal priority and road-space priority measures

Transit signal priority (TSP) may be combined with road-space priority (RSP) measures to increase its effectiveness. Previous studies have investigated the combination of TSP and RSP measures, such as TSP with dedicated bus lanes (DBLs) and TSP with queue jump lanes (QJLs). However, in these studies, combined effects are usually not compared with separate effects of each measure. In addition, there is no comprehensive study dedicated to understanding combined effects of TSP and RSP measures. It remains unclear whether combining TSP and RSP measures creates an additive effect where the combined effect of TSP and RSP measures is equal to the sum of their separate effects. The existence of such an additive effect would suggest considerable benefits from combining TSP and RSP measures. This paper explores combined effects of TSP and RSP measures, including TSP with DBLs and TSP with QJLs. Analytical results based on time-space diagrams indicate that at an intersection level, the combined effect on bus delay savings is smaller than the additive effect if there is no nearside bus stop and the traffic condition in the base case is under-saturated or near-saturated. With a near-side bus stop, the combined effect on bus delay savings at an intersection level can be better than the additive effect (or over-additive effect), depending on dwell time, distance from the bus stop to the stop line, traffic demand, and cycle length. In addition, analytical results suggest that at an arterial level, the combined effect on bus delay savings can be the over-additive effect with suitable signal offsets. These results are confirmed by a micro-simulation case study. Combined effects on arterial and side-street traffic delays are also discussed.     

软弱富水地层浅埋暗挖隧道地表沉降和支护结构受力的模型试验

以莞惠城际轨道交通工程项目GZH-5标段中DK32+300~DK32+927.303段为背景,通过2组模型试验,其中一组无超前注浆,另一组进行超前注浆,研究软弱富水地层浅埋暗挖隧道地表沉降和支护结构受力规律及超前注浆对其受力变形造成的影响,最后,针对软弱富水地层浅埋暗挖隧道施工,提出几点隧道工程设计和施工的相关建议。     

A systematic analysis of multimodal transport systems with road space distribution and responsive bus service

A smart design of transport systems involves efficient use and allocation of the limited urban road capacity in the multimodal environment. This paper intends to understand the system-wide effect of dividing the road space to the private and public transport modes and how the public transport service provider responds to the space changes. To this end, the bimodal dynamic user equilibrium is formulated for separated road space. The Macroscopic Fundamental Diagram (MFD) model is employed to depict the dynamics of the automobile traffic for its state-dependent feature, its inclusion of hypercongestion, and its advantage of capturing network topology. The delay of a bus trip depends on the running speed which is in turn affected by bus lane capacity and ridership. Within the proposed bimodal framework, the steady-state equilibrium traffic characteristics and the optimal bus fare and service frequency are analytically derived. The counter-intuitive properties of traffic condition, modal split, and behavior of bus operator in the hypercongestion are identified. To understand the interaction between the transport authority (for system benefit maximization) and the bus operator (for its own benefit maximization), we examine how the bus operator responds to space changes and how the system benefit is influenced with the road space allocation. With responsive bus service, the condition, under which expanding bus lane capacity is beneficial to the system as a whole, has been analytically established. Then the model is applied to the dynamic framework where the space allocation changes with varying demand and demand-responsive bus service. We compare the optimal bus services under different economic objectives, evaluate the system performance of the bimodal network, and explore the dynamic space allocation strategy for the sake of social welfare maximization.     

A cost-competitiveness analysis of charging infrastructure for electric bus operations

This study investigates the cost competitiveness of different types of charging infrastructure, including charging stations, charging lanes (via charging-while-driving technologies) and battery swapping stations, in support of an electric public transit system. To this end, we first establish mathematical models to investigate the optimal deployment of various charging facilities along the transit line and determine the optimal size of the electric bus fleet, as well as their batteries, to minimize total infrastructure and fleet costs while guaranteeing service frequency and satisfying the charging needs of the transit system. We then conduct an empirical analysis utilizing available real-world data. The results suggest that: (1) the service frequency, circulation length, and operating speed of a transit system may have a great impact on the cost competitiveness of different charging infrastructure; (2) charging lanes enabled by currently available inductive wireless charging technology are cost competitive for most of the existing bus rapid transit corridors; (3) swapping stations can yield a lower total cost than charging lanes and charging stations for transit systems with high operating speed and low service frequency; (4) charging stations are cost competitive only for transit systems with very low service frequency and short circulation; and (5) the key to making charging lanes more competitive for transit systems with low service frequency and high operating speed is to reduce their unit-length construction cost or enhance their charging power.     

Modeling the impacts of mandatory and discretionary lane-changing maneuvers

In this paper, a novel mesoscopic multilane model is proposed to enable simultaneous simulation of mandatory and discretionary lane-changing behaviors to realistically capture multilane traffic dynamics. The model considers lane specific fundamental diagrams to simulate dynamic heterogeneous lane flow distributions on expressways. Moreover, different priority levels are identified according to different lane-changing motivations and the corresponding levels of urgency. Then, an algorithm is proposed to estimate the dynamic mandatory and discretionary lane-changing demands. Finally, the lane flow propagation is defined by the reaction law of the demand–supply functions, which can be regarded as an extension of the Incremental-Transfer and/or Priority Incremental-Transfer principles. The proposed mesoscopic multilane cell transmission model is calibrated and validated on a complex weaving section of the State Route 241 freeway in Orange County, California, showing both the positive and negative impact of lane changing maneuvers, e.g., balancing effect and capacity drop, respectively. Moreover, the empirical study verifies that the model requires no additional data other than the cell transmission model does. Thus, the proposed model can be deployed as a simple simulation tool for accessing dynamic mesoscopic multilane traffic state from data available to most management centers, and also the potential application in predicting the impact of traffic incident or lane control strategy.     

A capacity maximization scheme for intersection management with automated vehicles

With the advent of connected and automated vehicle technology, in this paper, we propose an innovative intersection operation scheme named as MCross: Maximum Capacity inteRsection Operation Scheme with Signals. This new scheme maximizes intersection capacity by utilizing all lanes of a road simultaneously. Lane assignment and green durations are dynamically optimized by solving a multi-objective mixed-integer non-linear programming problem. The demand conditions under which full capacity can be achieved in MCross are derived analytically. Numerical examples show that MCross can almost double the intersection capacity (increase by as high as 99.51% in comparison to that in conventional signal operation scheme).     

高速路网不停车收费车道优化布设方法

合理设置高速公路收费站ETC (Electronic Toll Collection)车道数量，对高速公路通行效率至关重要。针对目前路网中ETC与MTC (Manual Toll Collection)车辆混行的情况，考虑ETC的普及率，结合多用户路网均衡模型和排队论方法，建立基于双层规划模型的高速路网ETC车道优化布设方法。上层模型以车辆总通行时间最小为目标，优化设置进出收费站的ETC车道数量；下层模型为多用户路网均衡模型，反映ETC和MTC车辆的路径和收费车道选择行为。下层模型通过设计收费站的等价拓扑结构，表征收费站的车道使用规则及车辆的收费车道选择行为，并采用排队论方法估计ETC和MTC车道的收费排队时间。根据模型的特点设计了基于主动集的启发式算法，利用参数二进制与拉格朗日函数法确定迭代下降方向，解决了下降方向与步长难以计算的问题；通过内嵌优化函数的方式，保证在主动集转化过程中上层约束均不会失效，且避免了迭代过程中的模型解退化问题。基于上海市绕城高速进行实证分析，结果表明：随着ETC普及率的提升，收费排队时长按照负指数趋势下降；与按比例布设ETC车道的方法相比，所提方法最高可降低57.4%的收费排队时间，且该方法可以避免ETC车道布设过多对于MTC车道通行能力挤压造成的负面效果。研究成果可以有效指导高速路网ETC车道的布设，提高路网通行效率。     

A proposed vision and vehicle-to-infrastructure communication-based vehicle positioning approach

It is essential to obtain accurate location of vehicles for new applications of Intelligent Transportation Systems. To remedy the defects of present Global Positioning System and vehicle-to-infrastructure (V-I) positioning technology, a new positioning approach based on vision and V-I communication is proposed. This approach aims at lane-level positioning with lower cost than conventional ones. In this approach, the position of the vehicle is represented by its lateral position (the lane number) and longitudinal position (the distance from entrance of the road) in a course coordinate system along the road; the specific lane the vehicle is occupying (the lane number) can be judged using the information of lane lines detected by vision systems; then the distance to the vehicle is obtained by a Road Side Unit (RSU) during the V-I communication; and the longitudinal position is calculated. The error of the approach on typical operating conditions is analyzed, indicating that the new approach can achieve the accuracy of less than 0.31 m for straight road and 0.58 m for typical arc road with ultra-wideband communication and ranging technologies and rational arrangement of RSUs. The feasibility of this approach is presented.