O''''ZBEKISTON型机车牵引风机柜振动及开裂问题处理方法探讨

文章运用ANSYS软件对O＇ZBEKISTON型机车牵引风机柜进行了模态分析和静态强度、刚度分析，认为机车牵引风机柜振动及开裂是因风柜的固有频率与风机的工作频率相接近、风道板的强度低、刚度小、风柜刚度分布不合理引起的。据此提出对风柜的改造方案，并对改造方案的可行性进行分析。     

Definition of wind blowers for vehicles testing at chassis-dyno facilities using a CFD approach

The need to increase measurement accuracy of fuel consumption and pollutant emissions in vehicles is forcing the market to develop chassis-dyno test cells that reproduce on-road conditions realistically.Air-cooling is key to vehicle performance. It is therefore critical that the design of a test cell guarantees realistic cooling of all vehicle components, as important errors in fuel consumption and emissions measurements may otherwise arise. In a test-room, a blower placed in front of the vehicle supplies the cooling air. While there are some guidelines in the literature for the selection of fans required for emissions measurements for standard driving cycles, the information for designing the air supply system for specific tests in other areas is scarce.New Real Driving Emissions (RDE) legislation will force manufacturers to perform on-road measurements of pollutants. This represents a significant challenge due to the variability of conditions coming from non-controlled parameters. In order to optimize vehicles, different tests are performed in cells equipped with a chassis-dyno where the on-road flow field around the vehicle is reproduced as closely as possible.This work provides some guidelines for the definition of the airflow supply system of chassis-dyno facilities for vehicle optimization tests, based on a CFD analysis of the flow characteristics around the vehicle. By comparison with the solution obtained for a vehicle in real road driving conditions, the exit section of the blower and the distance between the blower exit and the car that best reproduce realistic on-road flow conditions in a test room are determined.     

The influence of fully nonlinear wave forces on aero-hydro-elastic calculations of monopile wind turbines

The response of an offshore wind turbine tower and its monopile foundation has been investigated when exposed to linear and fully nonlinear irregular waves on four different water depths. The investigation focuses on the consequences of including full nonlinearity in the wave kinematics. The linear and nonlinear irregular wave realizations are calculated using the fully nonlinear potential flow wave model OceanWave3D [1]. The linear and nonlinear wave realizations are compared using both a static analysis on a fixed monopile and dynamic calculations with the aeroelastic code Flex5 [2]. The conclusion from this analysis is that linear wave theory is generally sufficient for estimating the fatigue loading, but wave nonlinearity is important in determining the ultimate design loads.     

基于Femap的风帆基座局部强度分析

以上海海事大学教学实习船"育明"轮为对象,研究船舶加装风帆装置的船体结构强度问题,通过局部加强风帆基座和船体连接部分来保证风帆安装部位的结构稳定性。利用Solidworks和Femap软件建立了风帆基座和船体的有限元模型,计算得到该模型在10级风载荷下受风角度从0°~60°的应力和应变。最终结果表明,在10级风载荷下,该船风帆基座和局部加强后的船体的强度符合要求。     

船用高温风机电机通风冷却风道数值研究

本文以某型船用高温风机电机为研究对象,并采用计算流体力学和数值传热学手段研究其通风冷却系统,对该船用高温风机电机通风冷却风道的流场与电机外壳表面的温度场开流固耦合数值模拟,得到了通风冷却风道的流场分布和电机外壳表面的温度场分布,并对电机外壳表面的温度分布情况进行分析。数值模拟结果可以为电机通风冷却系统的合理设计和安全可靠运行提供参考。     

Spar基础浮式风机系泊系统全耦合分析

本文以OC3 Hywind Spar基础浮式风机为研究对象,采用先进的空气动力-水动力耦合时域分析方法,针对其在中国南海某海域风浪流共同作用下,系泊系统、浮式基础运动以及风机与塔桶载荷响应进行分析。对比了定常风与湍流风模型对浮式风机系泊系统、整体运动响应以及风机载荷的影响。计算结果表明：相比于湍流风,采用定常风进行浮式风机系泊系统分析将得到偏于危险的结果,同时浮式风机运动响应与风机载荷结果偏小。本文建议在系泊系统初始设计阶段采用定常风方法进行设计,在系泊分析阶段采用湍流风进行分析,以保证浮式风机长期服役安全。     

风积砂填筑路基施工质量控制

通过工程实践,介绍采用风积砂填筑路基的施工工艺和质量控制过程。     

捷达CL型轿车鼓风与散热风扇电路及故障分析

用电路图分析捷达CL型轿车鼓风与散热风扇工作原理、作用及故障。     

一种进一步降低轿车空气阻力的方法

本文首先简要地分析了声激励减阻机理，然后，针对类似桑塔纳车身的模型采用了声激励的方法进行了减低空气阻力的研究，得出了声激励参数，方式和减阻效果的关系，并且对此进行了一定的分析，表明利用声激励方法可以进一步降低此类车身的空气阻力。     

酒泉至额济纳铁路防沙堤风洞试验数值模拟及积沙试验研究

防沙堤是造价低、使用广泛的工程防沙措施。对三角形和梯形截面防沙堤进行系统对比研究,总结出两种防沙堤的优缺点。通过风洞试验对不同断面形状的防沙堤的流场结构、流场压力分布、积沙情况进行对比研究,然后利用FLUENT数值模拟方法对风洞试验进行验证对比。研究结果和结论:(1)梯形横断面防沙堤迎风侧形成的低速区域宽度大于三角形,梯形迎风侧对沙粒的沉积、滞留作用优于三角形;(2)三角形横断面防沙堤背风侧产生的有效防护宽度大于梯形,防护效果优于梯形;(3)风沙流遇防沙堤阻挡在迎风侧坡脚受阻堆积,积沙达到堤体2/3高度时不再继续堆积增高,一部分向两侧随风流导向两端处,另一部分沿坡越过堤体顶部在落沙坡堆积。准备建设的风沙铁路酒额线及其他交通、民用建筑可以利用以上成果选择防沙堤的形状以达到最好防沙效益。