电机悬挂方式对LIM地铁系统动力特性的影响研究

研究目的：研究直线电机地铁在不同电机悬挂方式下的气隙变化规律及车辆、轨道的动力响应特性，并将二者进行比较。研究方法：应用车辆轨道耦合动力学理论，分别建立不同悬挂方式下的系统模型并编制相应的仿真程序，通过在轨道局部加入谐波型余弦不平顺激励对系统的动力特性进行分析。研究结果：2种悬挂方式对系统的各向加速度和轮轨力的影响差别较小，而气隙变化呈现明显不同的规律。研究结论：直线电机采用架悬式悬挂时，要严格控制幅值大于5．5mm的长波不平顺，防止电机和反力板之问的刮蹭；而当采用抱轴式悬挂时，要注意控制大幅值的短波不平顺出现，防止气隙过大，影响电机效率。     

鱼雷发动机三组元比例控制器数值模拟

利用计算流体力学软件Pumplinx模拟鱼雷发动机中三组元比例控制器的内部流场,分析计算中不同压差情况下对比例控制器性能的影响,以及叶片与定子间间隙大小对于比例控制器性能的影响,同时对不同叶片数目下性能进行对比。计算结果表明:由于比例控制器为被动旋转马达结构,其转速和流量均随时间呈周期性脉动变化,随着工作压差增大,转速脉动幅度基本保持不变,而流量和扭矩脉动幅值增加;随着间隙增大,泄漏量增大,但流量、扭矩、转速脉动幅值大幅降低,出口流量较为平稳;叶片数目增多后比例控制器转速降低、排量降低。由计算结果推断出目前比例控制器的最优叶片数目为4。本文可为进一步研究比例控制器精度问题提供参考。     

信号交叉口行人二次过街下右转车通行能力与延误估计模型

在充分分析典型四相位交叉口行人二次过街设置前、后的行人流与右转车流冲突的前提下，以行人过街时间占有率和行人群到达分布作为分析指标，利用可插车间隙理论得出行人单向通行和双向通行条件下的右转车通行能力计算公式；根据行人流随机消散和集中消散的不同特征，应用随机分布理论推导出右转车穿越行人流的延误模型；并通过算例对比分析行人二次过街设置前、后右转车通行能力和延误的变化值。结果表明，除了在少数行人流量比较大的情况下， 行人二次过街的设置会小幅度减少右转车的延误；在其他大多数情况下，行人二次过街设置后， 右转车的通行能力将受到限制，延误增大，其中，平均通行能力降低了16.68%，平均延误时间增大 了21%，所以，当右转车交通需求较大时，需同时考虑行人和右转车的交通运行状态，优化设计是否采用行人二次过街，避免右转车超出极限忍耐时间而增大与行人冲突的概率。     

Modeling the impacts of mandatory and discretionary lane-changing maneuvers

In this paper, a novel mesoscopic multilane model is proposed to enable simultaneous simulation of mandatory and discretionary lane-changing behaviors to realistically capture multilane traffic dynamics. The model considers lane specific fundamental diagrams to simulate dynamic heterogeneous lane flow distributions on expressways. Moreover, different priority levels are identified according to different lane-changing motivations and the corresponding levels of urgency. Then, an algorithm is proposed to estimate the dynamic mandatory and discretionary lane-changing demands. Finally, the lane flow propagation is defined by the reaction law of the demand–supply functions, which can be regarded as an extension of the Incremental-Transfer and/or Priority Incremental-Transfer principles. The proposed mesoscopic multilane cell transmission model is calibrated and validated on a complex weaving section of the State Route 241 freeway in Orange County, California, showing both the positive and negative impact of lane changing maneuvers, e.g., balancing effect and capacity drop, respectively. Moreover, the empirical study verifies that the model requires no additional data other than the cell transmission model does. Thus, the proposed model can be deployed as a simple simulation tool for accessing dynamic mesoscopic multilane traffic state from data available to most management centers, and also the potential application in predicting the impact of traffic incident or lane control strategy.     

北汽EV160纯电动汽车驱动系统异响故障诊断与排除

从故障现象原因入手,根据先外后内、先简后繁原则,对故障进行由外到内,先易到难的检查,然后依据厂家提供的数据参数,运用专用检测设备,对电机内部进行精确测量,通过数据对比分析,最终确定故障根源。     

浅谈轴系校中计算及Nauticus Shaft Alignment软件的应用

本文以介绍轴系校中的计算方法为主,同时简单介绍Nauticus Shaft Alignment软件在计算过程中的应用。轴系校中的目的在于通过调整各轴承的合理位置,使各个轴承上的负荷在各种工况下均能合理分配。     

SAC沥青混合料设计方法

通过对河北省沿海高速公路秦皇岛段进行重载交通长寿命半刚性基层沥青路面关键技术的研究,提出优化的SAC沥青混合料设计方法,尝试在解决沥青面层的早期破坏问题的同时满足面层的功能要求,可供同行参考。     

直线电机车辆牵引电机恒隙控制的初步研究

直线电机轨道车辆采用直线感应电机牵引、轮轨系统支撑导向,是一种新型城市轨道交通工具。本文介绍了直线电机的原理,对加拿大、日本以及广州4号线的直线电机车辆的不同牵引电机悬挂方式进行了对比分析,提出了在牵引电机悬挂系统中采用主动控制的恒隙技术的初步设想。     

Human driving data-based design of a vehicle adaptive cruise control algorithm

This paper presents a vehicle adaptive cruise control algorithm design with human factors considerations. Adaptive cruise control (ACC) systems should be acceptable to drivers. In order to be acceptable to drivers, the ACC systems need to be designed based on the analysis of human driver driving behaviour. Manual driving characteristics are investigated using real-world driving test data. The goal of the control algorithm is to achieve naturalistic behaviour of the controlled vehicle that would feel natural to the human driver in normal driving situations and to achieve safe vehicle behaviour in severe braking situations in which large decelerations are necessary. A non-dimensional warning index and inverse time-to-collision are used to evaluate driving situations. A confusion matrix method based on natural driving data sets was used to tune control parameters in the proposed ACC system. Using a simulation and a validated vehicle simulator, vehicle following characteristics of the controlled vehicle are compared with real-world manual driving radar sensor data. It is shown that the proposed control strategy can provide with natural following performance similar to human manual driving in both high speed driving and low speed stop-and-go situations and can prevent the vehicle-to-vehicle distance from dropping to an unsafe level in a variety of driving conditions.     

高速公路左侧路肩设置必要性研究

尽管<公路工程技术标准>(JTG B01-2003)中规定八车道的高速公路应当设置2.5 m的左侧硬路肩,但国内几条刚刚改建完成的八车道高速公路中没有一条设置了左侧硬路肩,甚至没有宽于0.75 m的路缘带.研究运用可接受间隙理论计算了不同流量和车道数条件下车辆从最内侧车道穿插变道停驶到右侧路肩这一过程的概率和所需距离,并通过交通事故数据调研,分析了左侧路肩设置对提高交通安全的影响,从运行效率和交通安全两个方面定性和定量分析了左侧路肩设置的必要性.