| AlSi5钎料在Q235钢板上的铺展试验研究 |
| |
| 引用本文： | 于治水 李瑞峰 祁凯. AlSi5钎料在Q235钢板上的铺展试验研究[J]. 华东船舶工业学院学报, 2005, 19(5): 82-85 |
| |
| 作者姓名： | 于治水 李瑞峰 祁凯 |
| |
| 作者单位： | [1]上海工程技术大学材料工程学院,上海200336 [2]江苏科技大学材料科学与程学院,江苏镇江212003 |
| |
| 基金项目： | 江苏省高校自然科学研究计划项目（04KJBl60007） |
| |
| 摘 要： | 采用TIG电弧钎焊试验方法，研究了在TIG电弧加热条件下，焊接参数变化对Al-Si钎料在Q235钢板上润湿、铺展行为的影响，结果表明燃弧时间和电流的增加，或弧长在一定范围内增加皆有利于AlSi5钎料在Q235钢板上的润湿和铺展；另外添加合适钎剂对提高AlSi5钎料铺展性能有利；同时表明交流电源时，由于正负极在不断变化，可导致Q235钢板上的氧化膜破坏，使钎料得到良好铺展。
|
| 关 键 词： | 电弧钎焊 AlSi5 钢 铺展 |
| 文章编号： | 1006-1088（2005）05-0082-04 |
| 收稿时间： | 2005-03-22 |
Experimental Research on Spreading of AISi5 Filler Metal on Q235 Steel |
| |
| YU Zhi-shui, LI Rui-feng , QI Kai. Experimental Research on Spreading of AISi5 Filler Metal on Q235 Steel[J]. Journal of East China Shipbuilding Institute(Natural Science Edition), 2005, 19(5): 82-85 |
| |
| Authors: | YU Zhi-shui LI Rui-feng QI Kai |
| |
| Affiliation: | 1. College of Materials Engineering, Shanghai University of Engineering Science, Shanghai 200336, China; 2. School of Materials Science and Eng., Jiangsu University of Science and Technology, Zhenjiang Jiangsu 212003, China |
| |
| Abstract: | The wetting and spreading behavior of AlSi5 filler on Q235 sheets is investigated under the condition of arc heating through the TIG arc brazing test. It can be seen that the increase of welding current, the arcing time and the arc length are propitious to the spreading of AlSi5 filler. Appropriate filler can also improve the properties of wetting and spreading. Experimental results show that the AC arc can destroy the oxidation film, and make AlSi5 filler spread well. |
| |
| Keywords: | arc brazing AlSi5 steel spreading |
| 本文献已被 维普 等数据库收录！ |
