Numerical and experimental investigation of lubricating oil flow in a gerotor pump

Gerotor pumps are widely used in the automotive industry for engine oil lubrication, due to their high volumetric efficiency and smooth pumping action. In many cases, the lubricating oil from the sump is mixed with contaminants, such as dust and tiny solid particles, or becomes thickened, due to aging. These problems will lead to critical situations, such as increased noise, enhanced wear and erosion, and poor lubrication of the engine. These critical situations were studied by conducting a detailed CFD integrated investigation on a gerotor pump’s performance at different operating conditions in three phases, and the results are presented in this paper. In first phase, a CFD model of a gerotor pump was developed with a dynamic mesh for the rotary movement of both the inner and outer rotors. The effects on pump flow rate of important parameters, such as rotor speed, fluid viscosity and number of ports, were simulated using non-contaminated oil at room temperature and an elevated temperature of 140oC. The relationship between flow rate and pressure at different rotor speeds was predicted and validated with test data for further parametric study. The pressure ripples at different time steps were measured at different angular positions of the rotors to examine the model accuracy. It was found that the flow rate increased and pressure pulsation, as well as flow recirculation, was reduced when ports were added to the cover plate. A suction pipe with a strainer was added for the second phase to capture the undesired changes in flow behavior, such as cavitation, which is caused by negative suction at the inlet region of pump. A suitable size for the inlet suction pipe for this pump was chosen after performing tests to characterize the flow behavior with single and double ports. Next, the relationship between pressure drop and strainer porosity was determined using different porosity values for the strainers. In the final phase, oil with different concentrations of solids was simulated to measure the effect of solid particles on flow rates and pressure losses. It was observed that the intensity of the recirculation was reduced at the suction end at the higher concentration of 0.04%, due to particle inertial effects. It was also found that particle size distribution affected the overall efficiency and pressure head of the pump.