Micro deformation of automobile hood in dipping process using stiffness

Technicians have been going through trial-and-error processes to solve very small or micro deformation on automobile hood during the painting process. In order to establish a systematic improvement procedure which can replace the time-consuming trial-and-error method to reduce defects, an accurate analysis of how micro deformation occurs during the painting process is needed. We have utilized a stiffness scanning method in automobile hood and reverse engineering to build up a reliable and accurate structural analysis and measurement procedures. We measured the load-stroke data at critical locations on automobile hood through stiffness scanning to determine material constants closest to the measurement by assuming several critical hood parts, such as sealer inside the hood, hemming part, spot weld part, and other uncertain joints, as virtual elastic materials. After setting the difference between analytical and measured load-stroke data as an objective function, we computed and minimized it by using the response surface method and partial differentiation of the object function. As a result, by obtaining the reliability was over 91%, which showed a strong correlation between analysis and measured results. By comparing the actual strain measured in real painting lines with calculated strain, we confirmed the validity of our structural analysis method. It was concluded that the proper analysis tool could be utilized in determination of optimal locations of supports during the painting process.