| 机车电机主动齿轮轴轴承布置分析 |
| |
| 引用本文： | 王秋允,张红军.机车电机主动齿轮轴轴承布置分析[J].机车电传动,2007(1):22-24,36. |
| |
| 作者姓名： | 王秋允 张红军 |
| |
| 作者单位： | 西南交通大学,牵引动力国家重点实验室,四川,成都,610031 |
| |
| 基金项目： | 教育部长江学者和创新团队发展计划 |
| |
| 摘 要： | 研究了现有的3种机车电机主动齿轮轴轴承布置方式.从轴承寿命和齿轮啮合2个方面对3种布置方式进行比较.使用有限元软件ANSYS计算分析了3种结构的齿轮轴变形和齿轮啮合时的应力.计算结果表明:主动齿轮轴两端支撑结构对轴承受力和齿轮啮合最有利.与传统主动齿轮悬臂结构相比两端支撑结构的轴承寿命提高了17.51倍、轮齿接触应力降低45.7%、轮齿齿根弯曲应力减小62.8%.
|
| 关 键 词： | 电机主动齿轮轴 轴承布置 轴承寿命 齿轮啮合 机车 机车电机 轮轴轴承 布置分析 Motor Locomotive Shaft Gear Driving Bearing 弯曲应力 齿根 应力降 接触 轮齿 寿命提高 悬臂结构 主动齿轮 承受力 支撑结构 齿轮轴 |
| 文章编号： | 1000-128X（2007）01-0022-03 |
| 修稿时间： | 2006-09-05 |
Analysis on Bearing Arrangement of Driving Gear Shaft of Locomotive Motor |
| |
| WANG Qiu-yun,ZHANG Hong-jun.Analysis on Bearing Arrangement of Driving Gear Shaft of Locomotive Motor[J].Electric Drive For Locomotive,2007(1):22-24,36. |
| |
| Authors: | WANG Qiu-yun ZHANG Hong-jun |
| |
| Institution: | Traction Power State Key Lab., Southwest Jiaotong University, Chengdu, Sichuan 610031, China |
| |
| Abstract: | R is studied the existing three kinds of bearing arrangement for the driving gear shaft of locomotive motor. Comparison is made between the three kinds of bearing arrangement modes in bearing life and gear mesh. ANSYS is used in calculating and analyzing the distortion of motor shaft and the stress of gear mesh. The result indicates that the two-terminal bracing structure is optimum for bearing load and gear mesh. Compared with the traditional cantilever structure, the bearing life of two-terminal bracing structure, is improved by 17.51 times, while the contact stress of gear tooth is reduced by 45.7%, and the bending stress of gear tooth is reduced by 62.8%. |
| |
| Keywords: | driving gear shaft of motor bearing arrangement bearing life gear mesh locomotive |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
