| 金属注射成形喂料的制备 |
| |
| 引用本文： | 乔斌,姬祖春,李映平.金属注射成形喂料的制备[J].江苏科技大学学报(社会科学版),2006,20(6):83-85. |
| |
| 作者姓名： | 乔斌 姬祖春 李映平 |
| |
| 作者单位： | 淮海工学院,机械工程系,江苏,连云港,222005;淮海工学院,机械工程系,江苏,连云港,222005;江苏科技大学,材料科学与工程学院,江苏,镇江,212003 |
| |
| 基金项目： | 淮海工学院重点学科建设项目(XK01007)，淮海工学院自然科学项目资助(Z200506) |
| |
| 摘 要： | 研究了石蜡(PW)和低密度聚乙烯(LDPE)的含量、粉末装载量和脱脂方法对脱脂保形性的影响。结果表明,低密度聚乙烯含量高、粉末装载量高有利于脱脂保形;经溶剂脱脂再进行热脱脂产生的缺陷比直接热脱脂产生的缺陷要少得多。
|
| 关 键 词： | 金属注射成形 喂料 粉末装载量 脱脂保形 |
| 文章编号： | 1673-4807（2006）06-0083-03 |
| 收稿时间： | 2006-07-31 |
| 修稿时间： | 2006年7月31日 |
Preparative Feed in Metal Injection Molding |
| |
| QIAO Bin,JI Zuchun,LI Yingping.Preparative Feed in Metal Injection Molding[J].Journal of Jiangsu University of Science and Technology:Natural Science Edition,2006,20(6):83-85. |
| |
| Authors: | QIAO Bin JI Zuchun LI Yingping |
| |
| Institution: | 1. Department of Mechanical Engineering, Huaihai Institute of Technology, Lianyungang Jiangsu 222005, China; 2. School of Materials Science and Engineering, Jiangsu University of Science and Technology, Zhenjiang Jiangsu 212003, China |
| |
| Abstract: | The influences of the content of PW and LDPE,the powder loading amount as well as the degreasing method on the shape holding in metal injection molding are investigated.Results indicate that higher content of LDPE and powder loading are good for the shape holding.Fewer faults may occur with solvent and then thermal degreasing than degreasing thermally only. |
| |
| Keywords: | metal injection molding feed powder loading shape holding |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
