首页 | 本学科首页   官方微博 | 高级检索  
     

智能汽车两阶段UWB定位算法
引用本文:朱冰, 陶晓文, 赵健, 柯敏, 王志伟, 李鑫. 智能汽车两阶段UWB定位算法[J]. 交通运输工程学报, 2021, 21(2): 256-266. doi: 10.19818/j.cnki.1671-1637.2021.02.022
作者姓名:朱冰  陶晓文  赵健  柯敏  王志伟  李鑫
作者单位:1.吉林大学 汽车仿真与控制国家重点实验室,吉林 长春 130022;;2.中国人民解放军空军航空大学 航空作战勤务学院,吉林 长春 130021
基金项目:国家重点研发计划项目2018YFB0105103国家自然科学基金项目51775235吉林省发改委科技项目2019C036-6吉林大学研究生创新研究计划项目101832020CX130吉林大学研究生创新研究计划项目101832020CX127
摘    要:为了提高智能汽车行驶的可靠性,以超宽带(UWB)为研究对象,研究了智能汽车两阶段UWB定位算法;分析了智能汽车UWB定位算法的基本原理与误差来源;建立了测距值筛选与加权位置解算两阶段UWB定位算法,在测距值筛选阶段,采用高斯筛选剔除小概率、大干扰事件,在加权位置解算过程中,根据多测距点的位置坐标加权计算得到最终的位置坐标,以有效减小非视距、多径效应所带来的误差,通过使用抗多径天线以有效减小多径效应所带来的误差,并分别建立了静态补偿和运动补偿策略,以有效减小设备晶振偏差等硬件问题造成的误差;在MATLAB/Simulink仿真平台中搭建一定测距方差约束下的UWB随机测距值仿真环境,对算法进行了仿真测试并与三边定位算法、三边质心定位算法进行仿真比较,分析基站数量对定位精度的影响;搭建实物UWB测试系统,对UWB设备定位精度进行了评估与误差补偿,并对两阶段UWB定位算法进行了实车测试。仿真结果表明:东向和北向的定位误差均值最小分别可达0.382 3、0.447 0 m;补偿后的UWB定位轨迹更接近RT3002所示的轨迹,东向和北向轨迹误差的平均值分别为0.049 2、0.017 8 m,均方根误差分别为0.069 8、0.0264 m。可见,提出的智能汽车两阶段UWB定位算法能够满足智能汽车的定位需求,具有高精度、低成本、稳定性好等优点。

关 键 词:汽车工程   智能汽车   高精度定位   路侧基站   UWB   运动补偿
收稿时间:2020-12-03

Two-stage UWB positioning algorithm of intelligent vehicle
ZHU Bing, TAO Xiao-wen, ZHAO Jian, KE Min, WANG Zhi-wei, LI Xin. Two-stage UWB positioning algorithm of intelligent vehicle[J]. Journal of Traffic and Transportation Engineering, 2021, 21(2): 256-266. doi: 10.19818/j.cnki.1671-1637.2021.02.022
Authors:ZHU Bing  TAO Xiao-wen  ZHAO Jian  KE Min  WANG Zhi-wei  LI Xin
Affiliation:1. State Key Laboratory of Automotive Simulation and Control, Jilin University, Changchun 130022, Jilin, China;;2. College of Aeronautical Combat Services, Aviation University of Air Force, Changchun 130021, Jilin, China
Abstract:To improve the driving reliability of intelligent vehicles, taking the ultra-wide band (UWB) as the research object, the two-stage UWB positioning algorithm for intelligent vehicles was studied. The basic principles and error sources of intelligent vehicle's UWB positioning algorithm were analyzed. A two-stage UWB positioning algorithm was established to filter the ranging values and calculate the weighted positions. In the filtering stage of ranging values, small probabilities and large interference events were eliminated through the Gaussian filtering. In the calculation stage of weighted positions, the final position coordinates were obtained by weighting the position coordinates of multiple ranging points to effectively reduce the errors caused by non-line-of-sight and multipath effects. The errors of multipath effects were effectively reduced by using the anti-multipath antennas, and the static and motion compensation strategies were established to effectively reduce the errors caused by hardware problems, such as the crystal deviation of the device. A simulation environment for UWB random ranging values under certain range variance constraints was built by using the MATLAB/Simulink simulation platform. The algorithm was simulated and compared with the trilateral positioning algorithm and the trilateral centroid positioning algorithm, and the impact of the number of base stations on positioning precision was analyzed. A physical UWB test system was built, the positioning precision of UWB equipment was evaluated, and the error compensation was performed. The two-stage UWB positioning algorithm was tested on a real vehicle. Simulation result shows that the mean values of positioning errors in the east and north directions can be as small as 0.382 3 and 0.447 0 m, respectively. The compensated UWB positioning trajectory is closer to the trajectory shown by RT3002. The average values of the east and north trajectory errors are 0.049 2 and 0.017 8 m, and the root mean square errors are 0.069 8 and 0.026 4 m, respectively. Thus, the proposed two-stage UWB positioning algorithm can meet the positioning requirements of intelligent vehicles, and has the advantages of high precision, low cost, and good stability. 2 tabs, 20 figs, 32 refs. 
Keywords:vehicle engineering  intelligent vehicle  high-precision positioning  roadside base station  UWB  motion compensation
本文献已被 万方数据 等数据库收录!
点击此处可从《交通运输工程学报》浏览原始摘要信息
点击此处可从《交通运输工程学报》下载免费的PDF全文
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号