| 柴油机燃烧放热模式分析 |
| |
| 引用本文： | 井恩泽,刘忠长,韩永强,李康,刘江唯.柴油机燃烧放热模式分析[J].车用发动机,2010(3). |
| |
| 作者姓名： | 井恩泽 刘忠长 韩永强 李康 刘江唯 |
| |
| 作者单位： | 1. 吉林大学汽车动态模拟国家重点实验室,吉林,长春,130022
2. 中国第一汽车集团公司技术中心,吉林,长春,130011 |
| |
| 基金项目： | 国家高新技术发展规化 |
| |
| 摘 要： | 研究了NOx和PM的机内净化方法,试验分析了EGR、高压喷射对柴油机排放的影响规律。在此基础上确定低NOx和低PM两种理想燃烧模式对应放热率参数的阈值。结果表明:NOx净化达到欧Ⅳ标准时,所对应的归一化放热率阈值为0.045~0.049°CA-1;PM净化达到欧Ⅳ标准时,对应的归一化放热率阈值为0.045~0.06°CA-1;二者同时达欧Ⅳ的归一化放热率阈值为二者的交集0.045~0.049°CA-1。
|
| 关 键 词： | 柴油机 放热率 废气再循环 高压喷射 排放 |
Analysis of Heat Release Mode for Diesel Engine |
| |
| JING En-ze,LIU Zhong-chang,HAN Yong-qiang,LI Kang,LIU Jiang-wei.Analysis of Heat Release Mode for Diesel Engine[J].Vehicle Engine,2010(3). |
| |
| Authors: | JING En-ze LIU Zhong-chang HAN Yong-qiang LI Kang LIU Jiang-wei |
| |
| Institution: | JING En-ze1,LIU Zhong-chang1,HAN Yong-qiang1,LI Kang2,LIU Jiang-wei2 (1.State Key laboratory of Automobile Dynamic Simulation,Jilin University,Changchun 130022,China,2.China FAW Group Corporation R&D Center,Changchun 130011,China) |
| |
| Abstract: | The inner engine control of NOx and PM emission was researched and the influences of high-pressure injection and EGR on diesel engine emission were analyzed.Based on this,the threshold values of heat release rate in low NOx and low PM ideal combustion modes were determined.The results show that the corresponding normalized heat release rate is 0.045-0.049 °CA-1 when the NOx emission meets the Euro Ⅳ requirement;and it is 0.045-0.06 °CA-1 when the PM emission satisfies the Euro Ⅳ requirement.As a result,it is 0.045-0.049 °CA-1 when the NOx and PM emission simultaneously reach the Euro Ⅳ standards. |
| |
| Keywords: | diesel engine heat release rate exhaust gas recirculation high-pressure injection emission |
| 本文献已被 CNKI 万方数据 等数据库收录！ |
|
