高速公路红砂岩路基施工技术与质量控制

阐述了针对红砂岩路用试验研究的结果,在施工中采取相应的工程技术措施对红砂岩的处治,使红砂岩路用性能得到改善.并介绍了高速公路红砂岩路基的施工技术、质量检测与控制.     

体外预应力高强混凝土薄壁箱梁试验研究

进行了体外预应力高强混凝土薄壁箱梁从预应力钢绞线张拉到承载力极限破坏这一全过程的试验研究,研究了体外预应力损失及应力增量、跨中截面应力—应变分布以及跨中挠度和抗裂性能等问题。研究结果表明:体外预应力高强混凝土薄壁箱梁预应力损失实测值与现行规范计算值基本吻合,探讨了其截面受压翼缘有效分布宽度和体外预应力筋应力增量的变化规律,初步揭示了体外预应力高强混凝土薄壁箱梁在混凝土开裂前和受拉非预应力钢筋屈服后混凝土受压翼缘存在不同的剪力滞效应,并提出了相应状态下的受压翼缘有效分布宽度系数。     

汽车隧道内气流及污染问题研究

研究了汽车隧道内的空气流动及污染扩散问题。对隧道内各种通风竖井进行简化,建立相应的隧道内空气总的运动方程。在采用龙格-库塔法求出流动情况的基础上,求解污染扩散方程,计算隧道内的污染纵向分布,从而建立了一套隧道内的流动及污染分布的工程估算方法。计算结果表明该方法的有效性,得出了使用不当的通风竖井方案反而会抑制隧道内污染物扩散的结论。     

混凝土泵车结构应力场分析与试验研究

建立了以板单元为基本单元的泵车有限元分析模型,利用MSC/NASTRAN软件对其进行了静强度分析,并进行了测试试验.计算结果与试验数据相吻合,验证了计算的正确性.找出了臂架过早出现裂纹的原因,并给出了结构改造的方法.     

斜拉桥预应力体系布置与施工质量控制

由于斜拉桥设计的受力要求,预应力体系在纵、横、竖三向均有布置,锚具使用的种类多、部位多,预应力张拉施工技术复杂、要求高、难度大.以长沙湘江北大桥的施工实例,对其布置体系、施工技术、质量控制及经验进行总结,并提出了施工中应注意的问题和处理方法.     

美国OTC 3545多功能汽车检测仪的应用

介绍如何应用美国SPX公司的OTC3545多功能汽车检测仪对汽车常规电气系统进行检测,以及与其它汽车检测仪相比,它所具有的突出优点。     

桥头搭板结构分析

将桥头间搭板简化为具有局部脱空的Winkler地基梁，针对不同的端部支承条件，对它在移动车辆荷载作用下的受力状况进行了全面分析，绘制了几种典型搭板的最大弯矩影响线图，给出了可用于搭板设计的诺模图。     

Bus Priority Using pre-signals

The need to provide efficient public transport services in urban areas has led to the implementation of bus priority measures in many congested cities. Much interest has recently centred on priority at signal controlled junctions, including the concept of pre-signals, where traffic signals are installed at or near the end of a with-flow bus lane to provide buses with priority access to the downstream junction. Although a number of pre-signals have now been installed in the U.K., particularly in London, there has been very little published research into their design, operation and optimisation. This paper addresses these points through the development of analytical procedures which allow pre-implementation evaluation of specific categories of pre-signals. The paper initially sets out three categories of pre-signal, which have different operating characteristics, different requirements for signalling and different impacts on capacity and delay. Key issues concerning signalling arrangements for these categories are then discussed, together with a summary of the analytical approach adopted and the assumptions required. Equations are developed to allow appropriate signal timings to be calculated for pre-signalised intersections. Further equations are then developed to enable delays to priority and non-priority traffic, with and without pre-signals, to be estimated with delay being taken here as the key performance criterion. The paper concludes with three application examples illustrating how the equations are applied and the impacts of pre-signals in different situations.The analyses confirm the potential benefits of pre-signals, where these signals apply to non-priority traffic only. Where buses are also subject to a pre-signal, it is shown that disbenefits to buses can often occur, unless bus detectors are used to gain priority signalling.     

城市公交线网优化的线性模型

为了对现有公交线网进行优化,有效利用现有交通资源,解决城市交通问题,运用系统科学的思想,通过对城市公交线网优化的主要内容、优化原则、优化目标以及约束条件的分析,兼顾考虑乘客出行时间、公交线网密度和公交企业的利益以及公交线网的布局对整个城市的交通系统的影响,提出了优化目标的函数表达式及相应约束条件的数学表达式,建立了公交线网优化的线性模型,并给出了运用逐步筛选法对所提出的数学模型进行求解的方法。     

骨架密实结构水泥稳定碎石离析原因及改善措施

骨架密实结构水泥稳定碎石混合料中粗集料的含量增加,实际使用过程中混合料离析的可能性较大.在分析其产生离析的原因后,分别从混合料的材料组成设计、混合料的拌和装车、运输和摊铺等方面提出了改进措施,同时给出了定量评价混合料离析程度的试验方法和相应指标.