A second order volume of fluid （VOF） scheme for numerical simulation of 2-D breaking waves

Among all environmental forces acting on ocean structures and marine vessels, those resulting from wave impacts are likely to yield the highest loads. Being highly nonlinear, transient and complex, a theoretical analysis of their impact would be impossible without numerical simulations. In this paper, a pressure-split two-stage numerical algorithm is proposed based on Volume Of Fluid (VOF) methodology. The algorithm is characterized by introduction of two pressures at each half and full cycle time step, and thus it is a second-order accurate algorithm in time. A simplified second-order Godunov-type solver is used for the continuity equations. The method is applied to simulation of breaking waves in a 2-D water tank, and a qualitative comparison with experimental photo observations is made. Quite consistent results are observed between simulations and experiments. Commercially available software and Boundary Integral Method (BIM) have also been used to simulate the same problem. The results from present code and BIM are in good agreement with respect to breaking location and timing, while the results obtained from the commercial software which is only first-order accurate in time has clearly showed a temporal and spatial lag, verifying the need to use a higher order numerical scheme.     

基于对流效应的寒区路堤块石层临界高度研究

为了研究块石路堤降温效应与块石层高度之间的关系,基于多孔介质自然对流理论和热传导理论引入了表征寒区块石路堤自然对流降温效应的自然对流指数,利用热传导温度分布函数获得了路堤自然对流指数随块石层高度变化的近似公式。分析表明:自然对流指数最小值对应于路堤块石层的最小高度,而其最大值对应于路堤块石层的最大高度。另外介绍了一种利用自然对流指数近似公式估算路堤块石层临界高度的方法,并具体给出了算例,最后进行了数值验算。结果表明:通过自然对流指数确定的临界高度可为寒区工程的路堤设计提供参考。     

复合励磁同步发电机的Matlab建模与仿真

通过对Matlab/Simulink中同步电机的内核模型进行改造,建立了双输出绕组的复合励磁同步发电机模型,并对单输出绕组的复合励磁同步发电机的励磁调节特性进行了仿真,仿真结果说明:本文提出的方法简捷有效.     

多元线性模型中可容许性估计的等价条件的证明

讨论了线性回归模型中未知参数矩C(OI)阵的线性估计的可容许性的一个等价条件,从而把参数C(OI)的线性可容许性估计性质进行了推广,并且证明了参数C(OI)的线性可容许性估计具有广义岭估计的形式.     

基于杆梁模型的舰船隔振系统功率流传递特性分析

针对舰船中比较典型的静不定隔振系统，建立了柔性基础上安装4个隔振器的隔振系统物理模型。对隔振器采用杆梁模型建模，隔振上层设备采用刚体模型，导出了静不定隔振系统的动力控制方程。使用振动功率流方法对隔振系统进行了功率流分析，并利用Matlab进行编程计算，计算结果表明杆梁模型隔振器对上下两端的功率流的减少有明显效果，隔振器的内部共振特性对隔振系统振动功率流具有显著的影响。对主要设计参数进行了讨论，得出了具有工程指导意义的结论。     

带有技术站改编的空车调整研究

以空车走行公里最少为目标,建立了带有技术站改编的空车调整模型,并应用LIUNGO进行求解。通过一算例证明,空车经过技术站改编可以大幅度减少空车走行公里。     

电信计费模型的设计

依据电信计费系统存在的问题,本文详细描述了电信计费模型的设计方法和各个模块的设计内容。     

滑床板摩擦力对尖轨不足位移的影响

为解决道岔尖轨不足位移问题,根据尖轨的特殊结构外形、受力特性和扳动机理,建立尖轨不足位移计算仿真模型,分析不同滑床板表面摩擦系数取值下尖轨不足位移的变化。结果表明:摩擦力是导致尖轨产生不足位移的主要原因;尖轨不足位移随滑床板摩擦系数的增加而增大,基本成线性递增关系;最后牵引点距尖轨跟端间间距越大,摩擦系数对不足位移的影响也越大。减小摩擦力和优化牵引点间距能够较好地控制尖轨不足位移。提出设置滚轮式滑床板方案,将轨底与滑床板间的滑动摩擦转化为滚动摩擦,并优化滚轮式滑床板布置方式,进一步减小了尖轨不足位移。     

时延网络控制系统的保性能控制研究

针对网络控制系统中存在的不确定时延，在传感器采用时间驱动，执行器与控制器采用事件驱动、时延小于一个采样周期的条件下，将网络控制系统建模为一类具有不确定性的线性离散系统并且其标称模型可控。围绕该标称模型，利用Lyapunov方法，基于相应的LMI可行解，给出网络控制系统保性能控制律的设计方法。通过仿真证明了该方法的有效性。     

A Note on Shor＇s Quantum Algorithm

Shor proposed a polynomial time algorithm for computing the order of one element in a multiplicative group using a quantum computer. Based on Miller＇s randomization, he then gave a factorization algorithm. But the algorithm has two shortcomings, the order must be even and the output might be a trivial factor. Actually, these drawbacks can be overcome if the number is an RSA modulus. Applying the special structure of the RSA modulus, an algorithm is presented to overcome the two shortcomings. The new algorithm improves Shor＇s algorithm for factoring RSA modulus. The cost of the factorization algorithm almost depends on the calculation of the order of 2 in the multiplication group.