长大货物车适应THDS轴温探测技术的研究

针对不适应THDS轴温探测系统的长大货物车,分析论证了现车轴箱改进方案适应THDS轴温探测的不足,并提出了轴箱优化方案。经计算、试验和装车验证表明,新轴箱可行、有效、安全,满足THDS轴温探测要求,保证了长大货物车运输安全。     

Extreme hawser tension assessment for FPSO vessel during offloading operation in Bohai bay

The Floating Production Storage and Offloading Unit (FPSO) is an offshore vessel that produces and stores crude oil prior to tanker transport.Robust prediction of extreme hawser tensions during Floating Production Storage and Offloading (FPSO) operation is an important safety concern. Excessive hawser tension may occur during offloading operations, posing an operational risk. In this paper, AQWA has been used to analyze vessel response due to hydrodynamic wave loads, acting on a specific FPSO vessel under actual sea conditions. Experimental validation of numerical results has been discussed as well.This paper advocates methodology for estimating extreme response statistics, based on simulations (or measurements). The modified ACER (averaged conditional exceedance rate) method is presented in brief detail. Proposed methodology provides an accurate extreme value prediction, utilizing all available data efficiently. In this study the estimated return level values, obtained by ACER method, are compared to the corresponding return level values obtained by Gumbel method. Based on the overall performance of the proposed method, it is concluded that the improved ACER method can provide more robust and accurate prediction of the extreme hawser tension.Data declustering issue has been addressed. Paper highlights ability of ACER method to account for a set of varying sea state probabilities, as required in engineering long term statistical analysis.Described approach may be well used at the vessel design stage, while defining optimal vessel parameters that would minimize potential FPSO hawser tension.     

兰州地铁地温分布特性及其演化规律

以兰州地铁所在地区为研究对象,实测地铁隧道开挖前的地温(简称为初始地温),根据实测数据,提出地铁初始地温预测模型公式。采用非稳态传热的数值模型,分析运营条件下地铁隧道围岩温度的演化规律。结果表明:兰州地铁初始地温随环境气温和埋深的变化而变化;年变温层位于自地表至埋深12m处;年恒温层位于埋深12m及其以下,温度为15℃左右;年变温层中,1年内初始地温变化规律与环境气温变化规律相似,近似呈正弦曲线状分布,但存在相位滞后的现象;1年中初始地温的振幅随埋深的增大呈指数下降趋势。在隧道内空气与围岩之间热交换中,兰州地铁隧道围岩的温度及其梯度、热透厚度(未达到极限时)均与隧道内环境温度、热交换时间成正相关关系,但与距隧道内壁的距离成负相关关系。     

某型直流充电柜温度场仿真

对某型直流充电柜满负载工况下温度场进行仿真,根据实验测量数据验证仿真结果准确性,成功完成了对充电柜温度场的建模仿真工作,并实现对初始模型的简化,为对整个充电站进行温度场建模仿真奠定了基础。     

考虑空车调配协调的货物列车开行方案优化研究

为实现空车调配与货物列车开行方案协调优化，结合基本运行图架构与车流径路，构建货运时空服务拓展网络。考虑配空与装卸取送、集编发等环节的时间接续要求，节点与区段不对流空车要求，以重车流全程运送与空车配送等广义总费用最少为目标，建立整数规划弧路模型。针对既有算法设计局限性，结合重车或空车配空的时间接续要求，提出将不同的 k 短路重车流方案与空车配空方案相关联的改进可行解构造方法，设计混合差分进化求解算法。实例研究表明，考虑空车调配进行重车、空车流组织协调优化，能够减少空车走行费用，及时满足装车需求，有效保证作业车流配合中转车流集结编组及时挂线，提高方案可实施性。     

The problem of cold starts: A closer look at mobile source emissions levels

While the phenomenon of excess vehicle emissions from cold-start conditions is well known, the magnitude and duration of this phenomenon is often unclear due to the complex chemical processes involved and uncertainty in the literature on this subject. This paper synthesizes key findings regarding the influence of ambient and engine temperatures on light-duty vehicle (LDV) emissions. Existing literature, as well as analytical tools like the U.S. Environmental Protection Agency’s Motor Vehicle Emission Simulator (MOVES), indicate that while total vehicle emissions have dropped significantly in recent years, those associated with cold starts can still constitute up to 80% for some pollutant species. Starting emissions are consistently found to make up a high proportion of total transportation-related methane (CH₄), nitrous oxide (N₂O), and volatile organic compounds (VOCs). After 3–4 min of vehicle operation, both the engine coolant and the catalytic converter have generally warmed, and emissions are significantly lower. This effect lasts roughly 45 min after the engine is shut off, though the cooling rate depends greatly on the emission species and ambient temperature. Electrically (pre-)heated catalysts, using the bigger batteries available on hybrid drivetrains and plug-in vehicles, may be the most cost-effective technology to bring down a sizable share of mobile source emissions. Trip chaining (to keep engines warm) and shifting to non-motorized modes for shorter trips, where the cold start can dominate emissions, are also valuable tactics.     

大跨度钢箱梁斜拉桥中跨合龙关键技术

以4座主跨超过400 m的钢箱梁斜拉桥中跨合龙控制为背景,对大跨度钢箱梁斜拉桥中跨合龙的2种方法进行对比分析,对合龙各主要工序的关键技术进行研究。提出了合龙段配切长度的计算公式和合龙口宽度连续观测的测点布置方式。建议:在调整好合龙口姿态后可不加压重,也可不采用临时劲性骨架锁定;采用无线采集设备采集合龙口结构的温度场,用激光测距仪测量合龙口宽度以提高观测效率和安全性;在悬臂施工阶段关注梁长累计误差并通过调整后续梁段的制造长度消除之。     

基于隧道检测钢筋分布不均状况下判定衬砌结构安全性应用研究

近年来隧道内出现的越来越多的质量安全事故,引起各方高度重视,相应的最适宜隧道主体工程衬砌质量控制的地质雷达无损检测方法被广泛应用。通过雷达无损检测可揭露出衬砌内欠厚、脱空、钢筋分布不均等大量各类型缺陷,针对欠厚脱空等缺陷制定的注浆或开窗等治理措施是目前工程中常见的整改闭合工序,但钢筋分布不均对结构安全影响如何判定,怎么界定处理尚无成熟方案与规定。本文针对隧道项目中实际检测出的钢筋分布不均缺陷,在不宜大范围扰动结构及围岩进行整治的情况下,以及在避免其他问题共存等不利因素的前提下,应用有限元数值模拟计算分析强度安全系数,并结合现场外观等综合因素对衬砌结构安全性进行分析判定研究。     

On the variance of recurrent traffic flow for statistical traffic assignment

This paper generalizes and extends classical traffic assignment models to characterize the statistical features of Origin-Destination (O-D) demands, link/path flow and link/path costs, all of which vary from day to day. The generalized statistical traffic assignment (GESTA) model has a clear multi-level variance structure. Flow variance is analytically decomposed into three sources, O-D demands, route choices and measurement errors. Consequently, optimal decisions on roadway design, maintenance, operations and planning can be made using estimated probability distributions of link/path flow and system performance. The statistical equilibrium in GESTA is mathematically defined. Its multi-level statistical structure well fits large-scale data mining techniques. The embedded route choice model is consistent with the settings of O-D demands considering link costs that vary from day to day. We propose a Method of Successive Averages (MSA) based solution algorithm to solve for GESTA. Its convergence and computational complexity are analyzed. Three example networks including a large-scale network are solved to provide insights for decision making and to demonstrate computational efficiency.     

大气压力和冷却液温度对柴油机性能影响的试验研究

利用内燃机高海拔(低气压)模拟试验系统,研究了大气压力和冷却液温度对柴油机性能与燃烧特性的影响规律。试验结果表明:随着进气压力降低,柴油机最高燃烧压力下降,缸内平均温度大幅升高,燃烧始点推迟且持续期延长,后燃严重,燃烧过程未能及时释放热量,动力性能和燃料经济性下降明显;随着冷却液温度的升高,最高燃烧压力增大,燃烧始点提前且持续期略有延长,燃烧重心略微前移,燃烧放热率减小,且大气压力越低冷却液温度对柴油机燃烧过程的影响越明显。在高海拔(低气压)条件下,提高柴油机冷却液工作温度,可以明显减少冷却液散热量,提高柴油机的热-功转换效率,显著改善柴油机的高原动力性和经济性,同时柴油机热负荷升高幅度并不大。