高压共轨式电控柴油机动态仿真研究

建立了一个准稳态的发动机非线性模型,该模型主要用于研究高压共轨式电控柴油机的动态特性以及各种控制参数对发动机性能的影响。以车用YC6112ZLQ柴油机为仿真对象,在MATLAB/SIMULINK环境下完成模型的建立并进行了动态过程的实时仿真,给出了典型稳态及动态过程的仿真结果。     

汽车无线电导向行驶系统

介绍GPS系统概况、GPS全球卫星定位系统的基本原理及固定电台汽车导向行驶系统。     

车载动态实时可视化交通信息服务系统

一种新型城市交通信息服务系统,它采用GPS接收机、数码像机、有线/无线智能传感器、辅以人工等方式完成路况信息采集,经控制中心处理后按1～3次/min频率生成全面、综合反映路况信息的实时、动态交通图,通过无线传输为公众提供实时、动态路况信息,并用全新概念的车载显示器Skipper显示路况信息,实现道路车辆均衡化、提高道路利用率。论述了其开发背景、系统构成及工作原理、核心产品开发与运用等。     

车辆振动瞬态分析及动荷载

以装有平衡悬架和全悬浮驾驶室的三轴载重车为研究对象,建立受多点位移激励的多自由度车辆振动模型。采用数值模拟方法生成路面的随机激励时域函数,对车辆振动系统进行瞬态分析,求得车辆动荷载的最大瞬时值并与采用功率谱分析得到的结果进行比较。     

排气动力效应在二冲程摩托车上的应用

排气动力效应对于二冲程摩托车的性能有很大影响，特别体现在排气净化消声器的结构设计中，设计得合理，将会在保证排放控制的前提下，动力性和经济性比原车都有所改善，已经通过模拟计算及实践获得了证明。     

Bus Priority Using pre-signals

The need to provide efficient public transport services in urban areas has led to the implementation of bus priority measures in many congested cities. Much interest has recently centred on priority at signal controlled junctions, including the concept of pre-signals, where traffic signals are installed at or near the end of a with-flow bus lane to provide buses with priority access to the downstream junction. Although a number of pre-signals have now been installed in the U.K., particularly in London, there has been very little published research into their design, operation and optimisation. This paper addresses these points through the development of analytical procedures which allow pre-implementation evaluation of specific categories of pre-signals. The paper initially sets out three categories of pre-signal, which have different operating characteristics, different requirements for signalling and different impacts on capacity and delay. Key issues concerning signalling arrangements for these categories are then discussed, together with a summary of the analytical approach adopted and the assumptions required. Equations are developed to allow appropriate signal timings to be calculated for pre-signalised intersections. Further equations are then developed to enable delays to priority and non-priority traffic, with and without pre-signals, to be estimated with delay being taken here as the key performance criterion. The paper concludes with three application examples illustrating how the equations are applied and the impacts of pre-signals in different situations.The analyses confirm the potential benefits of pre-signals, where these signals apply to non-priority traffic only. Where buses are also subject to a pre-signal, it is shown that disbenefits to buses can often occur, unless bus detectors are used to gain priority signalling.     

薄壁杆件六面体网格剖分的组装法

针对箱梁等薄壁杆件的六面体网格自动生成问题,提出以下算法:在内外壳表面上,根据其拓扑关系和几何位置,采用映射和插值的方法布设节点;根据各个壳节点三维位置和拓扑关系对其进行编号;采用动态规划的方法,根据壳之间的拓扑几何关系组装内外壳,统一节点编号,生成单元。应用以该方法编制的相应计算软件对一座三跨连续箱形梁桥进行网格剖分。结果表明:该算法简单,效率高,生成的单元质量好。     

非自由液化场地地基动力性能大型振动台模型试验研究

基于1∶10模型大型振动台试验,研究非自由液化场地的地基动力性能。液化场地条件下,与自由场地基相比,非自由场地地基的自振频率明显加大、动力耗能作用提高较小。土层液化前且在小震输入下,地基动力变形的线性特征较突出,主要表现为对地震波的动力放大作用,加速度反应自下而上逐渐增大;土层完全液化后,地基加速度反应自下而上也逐渐增大,这是由于液化地基的层间剪切运动加快且加快的速率自下而上逐渐增大所致。地基孔压变化主要受两方面因素影响:一是随埋深减小,孔压减小,但孔压比增大;二是离桩距离越近,孔压和孔压比越大。土层液化前,输入波主要峰值过后,自下而上孔压消散逐渐减慢。较大震输入下,自下而上孔压有减小的趋势,但最大孔压比均很快达到液化孔压比;输入波主要峰值过后,孔压消散很缓慢,尤其是孔压消散随埋深减小越来越慢。试验中还出现瞬时负孔压的有趣现象,这也许是由于可液化土层发生瞬时膨胀作用所致。     

小型铣刨机车体升降油缸动态过程的分析

通过对小型铣刨机车体升降系统的简化,建立了液压缸运动速度与流量的传递函数,并且在系统参数静态设计方法的基础上,考虑了系统参数对其动态特性的影响.     

大跨度钢管混凝土拱桥地震反应分析

利用有限元法分析大跨度钢管混凝土拱桥的地震反应，考虑了剪切变形的影响，用子空间迭代法分析了其振动规律和动力特性，应用反应谱法和时程分析法分析了该拱桥的地震反应，得出了一些有价值的结论。