Intermodal Transit System Coordination

In urban areas where transit demand is widely spread, passengers may be served by an intermodal transit system, consisting of a rail transit line (or a bus rapid transit route) and a number of feeder routes connecting at different transfer stations. In such a system, passengers may need one or more transfers to complete their journey. Therefore, scheduling vehicles operating in the system with special attention to reduce transfer time can contribute significantly to service quality improvements. Schedule synchronization may significantly reduce transfer delays at transfer stations where various routes interconnect. Since vehicle arrivals are stochastic, slack time allowances in vehicle schedules may be desirable to reduce the probability of missed connections. An objective total cost function, including supplier and user costs, is formulated for optimizing the coordination of a general intermodal transit network. A four-stage procedure is developed for determining the optimal coordination status among routes at every transfer station. Considering stochastic feeder vehicle arrivals at transfer stations, the slack times of coordinated routes are optimized, by balancing the savings from transfer delays and additional cost from slack delays and operating costs. The model thus developed is used to optimize the coordination of an intermodal transit network, while the impact of a range of factors on coordination (e.g., demand, standard deviation of vehicle arrival times, etc) is examined.     

Traffic noise studies in a tropical environment

This paper reports upon a survey of traffic noise annoyance in three residential districts of Trinidad, West Indies. Householder perceptions were solicited by means of a questionnaire survey and direct measurements of traffic noise levels were taken. The results were compared with surveys elsewhere. It was concluded that household status had little effect on annoyance perception, that at L₁₀ levels greater than 70 dB(A) at a dwelling facade the noise level is unacceptable. L₁₀ levels less than 65 dB(A) at the building facade are not perceived as annoying in the environment considered.     

A preliminary proposal for urban and transportation planning in response to the Great East Japan Earthquake

The purpose of this paper is to propose information of use in the reconstruction of urban transport and infrastructure in response to the Great East Japan Earthquake. In particular, knowledge of urban planning and transportation planning is summarized to help in drawing up physical plans.     

Modeling the relationships among urban passenger travel carbon dioxide emissions,transportation demand and supply,population density,and proxy policy variables

To support the development of policies that reduce greenhouse gas (GHG) emissions by encouraging reduced travel and increased use of efficient transportation modes, it is necessary to better understand the explanatory effects that transportation, population density, and policy variables have on passenger travel related CO₂ emissions. This study presents the development of a model of CO₂ emissions per capita as a function of various explanatory variables using data on 146 urbanized areas in the United States. The model takes into account selectivity bias resulting from the fact that adopting policies aimed at reducing emissions in an urbanized area may be partly driven by the presence of environmental concerns in that area. The results indicate that population density, transit share, freeway lane-miles per capita, private vehicle occupancy, and average travel time have a statistically significant explanatory effect on passenger travel related CO₂ emissions. In addition, the presence of automobile emissions inspection programs, which serves as a proxy indicator of other policies addressing environmental concerns and which could influence travelers in making environmentally favorable travel choices, markedly changes the manner in which transportation variables explain CO₂ emission levels.     

Speed variation during peak and off-peak hours on urban arterials in Shanghai

Increased speed variation on urban arterials is associated with reductions in both operational performance and safety. Traffic flow, mean speed, traffic control parameters and geometric design features are known to affect speed variation. An exploratory study of the relationships among these variables could provide a foundation for improving the operational and safety performance of urban arterials, however, such a study has been hampered by problems in measuring speeds. The measurement of speed has traditionally been accomplished using spot speed collection methods such as radar, laser and loop detectors. These methods can cover only limited locations, and consequently are not able to capture speed distributions along an entire network, or even throughout any single road segment. In Shanghai, it is possible to acquire the speed distribution of any roadway segment, over any period of interest, by capturing data from Shanghai’s 50,000+ taxis equipped with Global Positional Systems (GPS). These data, hereafter called Floating Car Data, were used to calculate mean speed and speed variation on 234 road segments from eight urban arterials in downtown Shanghai. Hierarchical models with random variables were developed to account for spatial correlations among segments within each arterial and heterogeneities among arterials. Considering that traffic demand changes throughout the day, AM peak, Noon off-peak, and PM peak hours were studied separately. Results showed that increases in number of lanes and number of access points, the presence of bus stops and increases in mean speed were all associated with increased speed variation, and that increases in traffic volume and traffic signal green times were associated with reduced speed variation. These findings can be used by engineers to minimize speed differences during the road network planning stage and continuing through the traffic management phase.     

Real-time automatic rescheduling strategy for an urban rail line by integrating the information of fault handling

In the operation of urban rails, faults are inevitable, which leads to deviation between the actual timetable and the planned timetable. In nowadays, timetable rescheduling strategies rarely integrate the information of fault handling. In this paper, we develop a real-time automatic rescheduling strategy, which integrates the dynamic information of fault handling. The rescheduled timetable is obtained by a mathematical optimization model, the constraints set of which is automatically generated and adjusted as more information of fault handling is feedback. Compared with the experience-based rescheduling methods, the automatic rescheduling strategy reacts more quickly, and uses the information of fault handling more efficiently. A simulation system for testing the automatic rescheduling strategy is built, which uses the data of the Beijing Yizhuang metro line. Via testing on the simulation system, the effectiveness and efficiency of the automatic rescheduling strategy are validated.     

The cost of equity: Assessing transit accessibility and social disparity using total travel cost

Social equity is increasingly incorporated as a long-term objective into urban transportation plans. Researchers use accessibility measures to assess equity issues, such as determining the amount of jobs reachable by marginalized groups within a defined travel time threshold and compare these measures across socioeconomic categories. However, allocating public transit resources in an equitable manner is not only related to travel time, but also related to the out-of-pocket cost of transit, which can represent a major barrier to accessibility for many disadvantaged groups. Therefore, this research proposes a set of new accessibility measures that incorporates both travel time and transit fares. It then applies those measures to determine whether people residing in socially disadvantaged neighborhoods in Montreal, Canada experience the same levels of transit accessibility as those living in other neighborhoods. Results are presented in terms of regional accessibility and trends by social indicator decile. Travel time accessibility measures estimate a higher number of jobs that can be reached compared to combined travel time and cost measures. However, the degree and impact of these measures varies across the social deciles. Compared to other groups in the region, residents of socially disadvantaged areas have more equitable accessibility to jobs using transit; this is reflected in smaller decreases in accessibility when fare costs are included. Generating new measures of accessibility combining travel time and transit fares provides more accurate measures that can be easily communicated by transportation planners and engineers to policy makers and the public since it translates accessibility measures to a dollar value.     

城市轨道交通车辆基地站场勘测内容和方法研究

车辆基地是城市轨道交通系统的重要组成部分,针对目前车辆基地勘测设计过程中普遍重设计轻勘测、缺乏系统的站场勘测内容与方法的现状,通过对行业、企业相关勘测规范的理解和归纳,结合自己勘测设计实践,系统论述车辆基地站场勘测内容和方法,主要包括车辆基地基线的测设和应用、地形测量、站场横断面测绘、专项调查与测绘等几方面,掌握车辆基地站场勘测内容和方法将为车辆基地设计与施工、节约用地、降低投资等方面发挥重要的作用。     

Urban transportation in Chinese cities: An efficiency assessment

We use 2008 data for 34 Chinese cities to compare urban transportation systems. The results show stronger eastern and central cities focusing more on high capacity and less on sustainable modes of transportation, while western cities do the opposite. Chinese cities with more sustainable transportation are also more likely to have lower gross domestic product per capita, be smaller, are less urbanized and have higher bus usage. This model needs to change to align with China’s new policy priorities.     

Continuous approximation for skip-stop operation in rail transit

Operating speed of a transit corridor is a key characteristic and has many consequences on its performance. It is generally accepted that an increased operating speed for a given fleet leads to reduced operating costs (per kilometer), travel and waiting times (three changes that can be computed precisely), an improved comfort and level of service, which can attract new passengers who are diverted from automobile (items harder to estimate precisely). That is why several operation schemes which aim to increase the operating speed are studied in the literature, such as deadheading, express services, and stop skipping.A novel category of solutions to this problem for one-way single-track rail transit is to perform accelerated transit operations with fixed stopping schedules. The concept is quite simple: as the time required for stopping at each station is an important part of travel time, reducing it would be a great achievement. Particular operations that take advantage of this idea already exist. This paper focuses on one of them: the skip-stop operation for rail transit lines using a single one-way track. It consists in defining three types of stations: AB stations where all the trains stop, and A and B stations where only half of the trains stop (stations type A and B are allocated interchangeably). This mode of operation is already described in the literature (Vuchic, 1973, Vuchic, 1976, Vuchic, 2005) and has been successfully implemented in the Metro system of Santiago, Chile.This work tackles the problem with a continuous approximation approach. The problem is described with a set of geographically dependent continuous parameters like the density of stations for a given line. Cost functions are built for a traditional (all-stop) operation and for skip-stop operation as described above. A simple example is presented to support this discussion. Finally, a discussion about the type of scenarios in which skip-stop operations are more beneficial is presented.