面向新型混合交通流的智能交叉口网络布局优化

考虑网联自动驾驶车辆(Connected Autonomous Vehicle, CAV)应用先进的车联网与自动驾驶技术，可以采用智能交叉口的组织形式，大幅提升交叉口的通行效率，为降低CAV与人工驾驶车辆(Human-driven Vehicle, HV)混行条件下城市交通系统的整体出行成本，提出智能交叉口在城 市交通网络中的布局优化问题，建立数学优化模型并求解。首先，基于对两类车辆行驶特性的分析，建立混合用户均衡模型，描述CAV与HV的路径选择行为；其次，从交通规划者的角度，以系统最优为目标，整合混合用户均衡模型，建立面向新型混合交通流的智能交叉口网络布局优化模型，并利用改进的遗传算法求解；最后，选取Sioux-Falls交通网络作为案例分析，验证模型与算法的有效性，并研究CAV渗透率变化对优化结果的影响。研究表明，智能交叉口在城市路网中的合理规划极大地提高了新型混行场景下城市交通系统的出行效率，同时，大幅降低了由于网联自动 驾驶单方面技术优势带来的CAV与HV的出行效率差距，增进了出行公平性。     

信号交叉口摩托车与汽车混合交通流运行特性分析

摩托车出行在近期是我国中小城市居民的主要出行方式之一,因此摩托车、汽车混合交通流也是我国很多中小城市主要的机动车交通流形式。摩托车车流与汽车车流在道路上行驶的行为与特征上存在的差异较大。本文在对摩托车、汽车的混合交通流信号交叉口的实际调查基础上,将摩托车与汽车的相关数据分开进行统计分析,得到了较为符合实际的摩托车、汽车混合交通流在信号交叉口的特征,对交叉口的设计、提高信号交叉口的安全性和通行能力有重要的意义。     

A two-dimensional simulation model for modelling turning vehicles at mixed-flow intersections

The turning behavior is one of the most challenging driving maneuvers under non-protected phase at mixed-flow intersections. Currently, one-dimensional simulation models focus on car-following and gap-acceptance behaviors in pre-defined lanes with few lane-changing behaviors, and they cannot model the lateral and longitudinal behaviors simultaneously, which has limitation in representing the realistic turning behavior. This paper proposes a three-layered “plan-decision-action” (PDA) framework to obtain acceleration and angular velocity in the turning process. The plan layer firstly calculates the two-dimensional optimal path and dynamically adjusts the trajectories according to interacting objects. The decision layer then uses the decision tree method to select a suitable behavior in three alternatives: car-following, turning and yielding. Finally, in the action layer, a set of corresponding operational models specify the decided behavior into control parameters. The proposed model is tested by reproducing 210 trajectories of left-turn vehicles at a two-phase mixed-flow intersection in Shanghai. As a result, the simulation reproduces the variation of trajectories, while the coverage rate of the trajectories is 88.8%. Meanwhile, both the travel time and post-encroachment time of simulation and empirical turning vehicles are similar and do not show statistically significant difference.     

Noise level in the vicinity of signalized roundabouts

The analysis, assessment and estimation of noise levels in the vicinity of intersections is a more complex problem than a similar analysis for roads and streets. This is due to the varied geometry of the intersections, differences in the loads of individual movements, participation of heavy vehicles and mass transport vehicles, as well as the various types of traffic management and traffic control. This article analyses the influence of intersection type and traffic characteristics on the noise levels in the vicinity of classic channelized intersections with signalization, roundabouts and signalized roundabouts. Based on the conducted measurements, it has been established that, with comparable traffic parameters and the same distance from the geometric centre of the intersection, the L_Aeq value for signalized roundabouts is 2.5–10.8 dB higher in comparison to classic channelized intersections with signalization and 3.3–6.7 dB higher in relations to the analysed roundabout. Additionally the differences between L_Aeq levels at individual entries at the same signalized roundabouts may reach the value of approximately 4.5 dB. Such situation is influenced by differences in the intersection geometry, diameter of the intersection’s central island, traffic flow type, traffic management at the entries and traffic volume, especially the amount and traffic movements of multiple axle heavy vehicles. These factors have been analysed in detail in relation to signalized roundabouts in this paper.     

A macroscopic theory for unsignalized intersections

The following paper presents a dynamic macroscopic model for unsignalized intersections which accounts for time-limited disruptions in the minor stream flow, even in free-flow conditions when the average flow demand is satisfied. It introduces a deterministic fictive traffic light to represent an average alternating sequence of available and busy time periods for insertion depending on the major stream flow. Two allocation schemes of the total outflow during green periods are developed to model the influence or non-influence of the minor stream over the major stream flow. The aggregation of the resulting dynamic flow variations gives relevant capacity values. Moreover, the model predicts accurate average vehicle delay and queue length estimates compared to theoretical and empirical data. It has three easy-to-measure parameters and can be integrated into a dynamic macroscopic simulation tool for urban networks.     

关于城市道路规划设计几个问题的探讨

本文主要论述城市道路规划设计应正确认识道路环境、道路功能、重视道路等级与里程长度以及路口与路段通行能力的协调配合。     

基于冲突技术法的主路优先交叉口通行能力研究

在分析主路优先交叉口交通特性的基础上，确定交通流优先等级，引入冲突技术法构建通行能力模型。以442型交叉口为例，给出不同车道布局形式下的通行能力计算模型。通过实例分析，给出了模型中各参数的建议值，并验证了模型的有效性。     

出口道左转交叉口信号控制鲁棒优化方法

为了提高出口道左转交叉口在现实交通需求和供给波动环境中的适应性，权衡运行效率与稳定性，对其鲁棒优化方法进行研究。在对出口道左转交叉口运行特点和饱和流率进行分析的基础上，提出从交通需求分布、基本饱和流率分布和实际运行车速分布3个方面考虑交通的波动性，以适应出口道左转交叉口交通供给波动与控制方案相关联的特征。在此基础上，分别以平均值-标准差最小、条件风险值最小和最大值最小化为目标，建立3种信号控制鲁棒优化方法，并基于遗传算法建立求解算法。通过算例分析，对鲁棒优化算法的准确性、平均值-标准差模型的参数取值和3种鲁棒优化方法优化效益进行分析。研究结果表明：所建立的鲁棒优化方法可实现交通需求和供给波动下出口道左转交叉口信号控制与设计车速的优化设计，相较于传统控制方案其在保证效率的前提下提高了控制方案运行的稳定性；平均值-标准差模型和条件风险值模型对于各项指标均表现较好，可在保障平均延误维持较优值的基础上（案例中车均延误增加小于3%）显著改善运行效果的稳定性（案例中延误标准差减少约40%）；最小-最大模型对延误最大值的优化效果最佳，但其对于控制方案的整体效率会造成较大的负面影响（案例中车均延误增加了8.19%）。