考虑移步需求的无桩型共享单车动态调度研究

共享单车系统自发的不均衡性导致单车数量分布与用户需求分布之间产生偏移，降低了系统服务能力，需要调度实现再平衡. 现有动态调度算法缺乏考虑起点车辆供给不足，用户在出行过程中“再次”取车的移步需求，难以准确识别用户真实的出行需求分布，降低了调度效果. 本文提出以用户出行选择行为为下层，以调度车辆路径规划为上层的双层规划模型框架，设计结合仿真系统的启发式求解算法. 算例场景基于上海市虹口、杨浦区共享单车历史出行数据搭建，并进行网格化处理. 算例结果表明，模型能有效识别移步需求，提高共享单车的供需匹配能力. 针对各类调度资源配置情况，共享单车的供需匹配率提升18.07%~ 19.89%，提高了共享单车系统的管理效率.     

频繁爆破下隧道内振动传播的数值研究

为揭示频繁爆破下隧道内振动传播衰减规律,文章以蒙华铁路段家坪隧道为工程背景,利用LS-DY NA建立了三维隧道模型,模拟分析了多次爆破下隧道内近区和中远区的振动传播规律。结果表明,质点垂向峰值振速随距离和爆破次数的增大而减小,少数振速有增大的现象;近区振动衰减较快,中远区振动衰减比近区缓慢;中远区a值比近区至少小12.5%,但整体上二者的a值随爆破作用次数的增加呈缓慢上升趋势;系数K随爆破作用次数的增加而降低,近区K值降低速率普遍大于中远区,且近区K值比中远区至少大29.1%;频繁爆破下,中远区比近区较符合萨道夫斯基经验公式。     

Simulating the air quality impacts of traffic calming schemes in a dense urban neighborhood

In this study, the effects of isolated traffic calming measures and area-wide calming schemes on air quality in a dense neighborhood were estimated using a combination of microscopic traffic simulation, emission, and dispersion modeling. Results indicated that traffic calming measures did not have as large an effect on nitrogen dioxide (NO₂) concentrations as the effect observed on nitrogen oxide (NO_x) emissions. Changes in emissions resulted in highly disproportional changes in pollutant levels due to daily meteorological conditions, road geometry and orientation with respect to the wind. Average NO₂ levels increased between 0.1% and 10% with respect to the base-case while changes in NO_x emissions varied between 5% and 160%. Moreover, higher wind speeds decreased NO₂ concentrations on both sides of the roadway. Among the traffic calming measures, speed bumps produced the highest increases in NO₂ levels.     

救助船模拟器原型机关键技术研究

针对大风浪条件下救助船操纵训练的要求，有必要开发针对救助船的操纵模拟器。相比于传统的通用船舶模拟器，救助船模拟器原型机系统中引入六自由度平台运动系统，基于UDP协议传输船舶姿态数据实现实时体感模拟功能，可以模拟船舶在大风浪条件下剧烈摇动的操船环境，提高模拟训练的真实感。此外，系统中引入救助作业模拟模块的思想，可以更好地评估、训练船员在恶劣海况下配合其他救助人员完成救助任务的能力，提高执行海上救助任务的成功率与效率。     

A methodology for evaluating the performance of model-based traffic prediction systems

Model-based traffic prediction systems (mbTPS) are a central component of the decision support and ICM (integrated corridor management) systems currently used in several large urban traffic management centers. These models are intended to generate real-time predictions of the system’s response to candidate operational interventions. They must therefore be kept calibrated and trustworthy. The methodologies currently available for tracking the validity of a mbTPS have been adapted from approaches originally designed for off-line operational planning models. These approaches are insensitive to the complexity of the network and to the amount and quality of the data available. They also require significant human intervention and are therefore not suitable for real-time monitoring. This paper outlines a set of criteria for designing tests that are appropriate for the mbTPS task. It also proposes a test that meets the criteria. The test compares the predictions of the mbTPS in question to those of a model-less alternative. A t-test is used to determine whether the predictions of the mbTPS are superior to those of the model-less predictor. The approach is applied to two different systems using data from the I-210 freeway in Southern California.     

Distributed MPC for cooperative highway driving and energy-economy validation via microscopic simulations

Traffic congestion and energy issues have set a high bar for current ground transportation systems. With advances in vehicular communication technologies, collaborations of connected vehicles have becoming a fundamental block to build automated highway transportation systems of high efficiency. This paper presents a distributed optimal control scheme that takes into account macroscopic traffic management and microscopic vehicle dynamics to achieve efficiently cooperative highway driving. Critical traffic information beyond the scope of human perception is obtained from connected vehicles downstream to establish necessary traffic management mitigating congestion. With backpropagating traffic management advice, a connected vehicle having an adjustment intention exchanges control-oriented information with immediately connected neighbors to establish potential cooperation consensus, and to generate cooperative control actions. To achieve this goal, a distributed model predictive control (DMPC) scheme is developed accounting for driving safety and efficiency. By coupling the states of collaborators in the optimization index, connected vehicles achieve fundamental highway maneuvers cooperatively and optimally. The performance of the distributed control scheme and the energy-saving potential of conducting such cooperation are tested in a mixed highway traffic environment by the means of microscopic simulations.     

基于PLC的模糊频载调节器设计

介绍可编程序控制器(PLC)实现船舶电站模糊调频调载的软硬件实现方法,采用离线计算、在线查表的方法在PLC上实现模糊控制,利用硬件在环仿真进行试验研究,结果表明,智能频载控制器具有较好的稳、动态性能。     

W-SPSA in practice: Approximation of weight matrices and calibration of traffic simulation models

The development and calibration of complex traffic models demands parsimonious techniques, because such models often involve hundreds of thousands of unknown parameters. The Weighted Simultaneous Perturbation Stochastic Approximation (W-SPSA) algorithm has been proven more efficient than its predecessor SPSA (Spall, 1998), particularly in situations where the correlation structure of the variables is not homogeneous. This is crucial in traffic simulation models where effectively some variables (e.g. readings from certain sensors) are strongly correlated, both in time and space, with some other variables (e.g. certain OD flows). In situations with reasonably sized traffic networks, the difference is relevant considering computational constraints. However, W-SPSA relies on determining a proper weight matrix (W) that represents those correlations, and such a process has been so far an open problem, and only heuristic approaches to obtain it have been considered.This paper presents W-SPSA in a formally comprehensive way, where effectively SPSA becomes an instance of W-SPSA, and explores alternative approaches for determining the matrix W. We demonstrate that, relying on a few simplifications that marginally affect the final solution, we can obtain W matrices that considerably outperform SPSA. We analyse the performance of our proposed algorithm in two applications in motorway networks in Singapore and Portugal, using a dynamic traffic assignment model and a microscopic traffic simulator, respectively.     

立交隧道相互作用三维数值模拟与实测对比研究

以温福铁路琯头岭隧道下穿同三高速公路隧道为例,研究新建下穿隧道与既有隧道工程之间相互影响的问题。采用ANSYS有限元软件,模拟上覆公路隧道和下穿铁路隧道的位移和应力变化情况,并与现场监控量测结果对比,得到以下结果:下穿隧道拱顶沉降量较小,水平收敛值较大,下穿隧道立交段拱腰和边墙是需要重点支护的对象;上覆隧道在立交段下沉值变大,变化幅度为仰拱边墙拱腰拱顶,隧道中部和下部水平收敛值变化较大;受下穿隧道开挖影响,立交隧道上覆地层受力产生不均匀变化,造成扭矩存在,地面水平位移整体呈现"8"字形,立交隧道的建设对地层产生了较大的转动扰动。     

薄基岩顶板隧道爆破施工围岩稳定性分析

为更有效地进行薄基岩顶板条件下隧道施工安全控制,以某高速公路隧道为工程背景,运用数值模拟的方法,分别研究不同顶板厚度下隧道爆破施工引起的围岩振速分布特征及其对围岩的损伤情况,并进行围岩稳定性分析。结果表明:1)当顶板厚度在5 m及以上时,围岩是稳定的;2)当顶板厚度为3 m时,最危险横断面上基岩顶板内开始产生严重的拉伸裂缝及一些径向裂缝,将形成超挖;3)当顶板厚度≤2 m时,径向裂缝贯穿顶板岩体,围岩稳定性较差,在掌子面后1 m内可能发生塌落、掉块等事故。